This past Summer we have updated our classic instruction guide on How to Tap a Maple Tree. We’re always looking to improve the product and information to make it as easy as possible to use. With that in mind, we have added some new information to our classic guide originally published in 2013.
The Kaito Ridge Tree Tapping Instruction Quick Guide (Updated August, 2020)
How to Tap a Maple Tree
After properly identifying your maple trees, you are ready to begin tapping!
- Gather the tools for the job: drill (cordless preferred), hammer, food grade collection container, and a 5/16” drill bit.
- Locate the tree’s southern exposure. The side facing south tends to produce sap earlier than other sides of the trees.
- Measure the height of the tap hole carefully before drilling. The tap height is based on the total height of your collection container and the length of tubing. Be careful not to drill too high up, or your tube will not reach your container.
- Drill into the tree approximately 1” past the bark, into the white wood, at a very slight upward angle. Total depth will be approximately 1.5 to 2”. Remember to use caution and wear eye protection while drilling. Do not blow into the tap hole to clear debris. Doing so can introduce bacteria into the tree which can reduce sap yield.
- Insert the smooth end of the spout into the tree. while the barbed end inserts into your blue tubing. (Pro Tip: place the end of the tubing into hot water for 10 seconds to soften the tube and ease the attachment of the tube to the spout!).
- Lightly tap the spout into the tree, and be careful not to hammer the spout in too far or it will be difficult to remove. It is better to have the spout slightly loose than to have it stuck in the tree.
- Connect your tubing to a food grade collection container. We suggest using a large white 5 gallon food grade bucket with lid. An empty 1 gallon spring water jug can also be used. Be sure to check the collection container daily, up to twice a day (morning and night) as the flow of sap varies by tree and temperature. Two trees on the same property right next to each other may produce different amounts of sap. This is normal.
- When you’re finished collection, the equipment can be cleaned and reused next year! (Pro Tip: to ease disassembly of the tube and spout, place in hot water again for 10 seconds to soften the tube.) Do not insert anything into the tree’s tap hole when your season is finished, Maple trees are self-healing and will repair the hole themselves.
For more information on how to boil down your collected sap, identify the different types of maple and birch trees or to learn more about sugaring, visit us online at http://www.kaitoridge.com
US Copyright Kaito Ridge 2020